800G QSFP-DD AOC with CDR (TX / RX) Multimode Fiber, 1 - 30 m

Universal Active Optical Cable (AOC) with CDR (TX / RX), 1 - 30 m
Use FLEXBOX in combination with FLEXSOX to configure to almost any vendor
QSFP-DD to QSFP-DD
PAM4 modulated signal
Supported Datarate 850 Gbit/s
Modules are permanently attached to each end
Low power consumption < 30 W (less than 15 W per terminal)
Easy cable routing thanks to small diameter (Ø 2 mm) and bend radius
Connect different host systems by configuring each side individually
Specs
  • Fiber
  • 1m - 30m
  • 850 G
  • Active
Protocols
  • 100G ETH
  • 200G ETH
  • 400G ETH
  • 800G ETH
Part number
D.A858HG.z
You can create a quote from your cart.
Just go to cart and click CREATE QUOTE.

Specification

Type AOC
Form Factor QSFP-DD to QSFP-DD
Interface Active Optical Cable
Cable Type Optical Fiber
Temperature Range 0°C - 70°C
Bandwidth 850 Gbit/s
Digital Diagnostic Management (DDM) implemented
Power Consumption 30 W (15 W + 15 W)
CDR TX and RX
Modulation PAM4
Supported Protocols 800G Ethernet, 400G Ethernet, 200G Ethernet, 100G Ethernet

Transceiver Configuration with FLEXBOX

It's that easy to use
Insert Transceiver into FLEXBOX
1. Insert Into FLEXBOX
Select and Configure
2. Select And Configure
  • Choose vendor and compatibility
  • Press play
  • Configuration only takes a few seconds
Use with Device
3. Use With Device
  • Use the transceiver in your device. That's it!
  • Need it for another device? - Re-configure it again and again

What customers say

Great. FLEXBOX does what it says on the tin! - just connect, configure Transceiver and be happy.
James Rice Jump Networks Ltd

The flexbox has been an amazing tool for our Equinix AM5 deployments, we have used many brands previously however the flexbox was superior right from the start, especially when working in the datacenter and not needing to hold my laptop in my hand but my phone, which is just amazing for rapid deployments.

Looking forward to keep using the flexbox in the future! :)

Stan van de Klippe Chief Executive Officer-royalehosting.net
Our engineers spend a lot of time in data centers connecting switches and routers from different vendors. With the FLEXOPTIX service not only their task gets easier, also the back office doesn't have to have a broad range of optics from different vendors in stock anymore. The days that an engineer stand next to a router with an optic from the wrong vendor are over. With the FLEXOPTIX FLEXBOX the engineer simply reconfigures the optic, and that’s that. As an added benefit with the FLEXBOX there is no need to connect a new cross-connect to a device to see if it is connected on the other side. The measurement option that comes with the FLEXBOX are very handy!
Thomas Verschuren Technical Consultant, IP Visie Networking B.V.
The FLEXBOX was easy to set up and use, and the programmable transceivers worked seamlessly in several different brand devices. This will make our spares much easier to manage.
Shaun James Engineering Inspector, Tata Steel Strip Products UK
More