800G QSFP-DD 2x LR4 with dual CDR 10 km, λ1271-1331 nm, LC-Duplex, Singlemode
- int. Mux
- 10 km
- 2x 425 G
- LC
- 2x 400G ETH
- 400G ETH
- 800G ETH
-
Alternatives
-
Matching Products
-
Alternatives
-
Matching Products
Specification
Form Factor | QSFP-DD |
---|---|
Connector / Polish | 2x LC-Duplex PC |
Interface | Singlemode |
Compliance Code | 2x LR4 |
Distance | 10 km |
Temperature Range | 0°C - 70°C |
Lane Count | 8x (Tx/Rx) |
Bandwidth | 2x 425 Gbit/s |
Bandwith Per Lane | 106.25 Gbit/s |
Digital Diagnostic Management (DDM) | Yes, internally calibrated |
---|---|
Power Consumption | 14 W |
CDR | TX and RX |
SGMII | No |
Inbuilt FEC | No |
Powerbudget (dB) | 4.1 dB |
Transmit min/max per lane | -2.7 dBm / 5.1 dBm |
Receiver min/max per lane | -6.8 dBm / 5.1 dBm (overload) @400G |
Wavelength TX (Typical) | 1271 nm, 1271 nm, 1291 nm, 1291 nm, 1311 nm, 1311 nm, 1331 nm, 1331 nm |
Wavelength RX (Typical) | 1271 nm, 1271 nm, 1291 nm, 1291 nm, 1311 nm, 1311 nm, 1331 nm, 1331 nm |
---|---|
Laser | EML |
Receiver Type | PIN |
Modulation | PAM4 @400G |
Transmit and Dispersion Penalty | 3.9 dB |
Extinction Ratio | 3.5 dB |
Supported Protocols | 2x 400G Ethernet, 800G Ethernet, 400G Ethernet |
Configure Transceiver Using Your FLEXSOX
It's that easy to use- Slide your FLEXBOX V4 into your FLEXSOX
- Connect it via USB
- Start our FLEXOPTIX App
- Insert a Universal Transceiver into the corresponding slot
- Choose vendor and compatibility
- Press play
- Configuration only takes a few seconds
- Use the transceiver in your device. That's it!
- Need it for another device? - Re-configure it again and again
Compatibility
All trademarks, registered companies & references cited are the sole property of their respective company and are used solely to assist in the identification of products.
- MSA Standard compatible
What customers say
I had the chance to flash my first transceiver with the flexbox and also navigate through the different tools on the Windows App. I must say that I’m impressed by the flexibility and available features provided by this app and the Flexbox. I flashed a 1G LX optic to be compatible with a HP switch in production (Aruba Networks(ex. HP Network) / J4858A) and the switch immediately recognized the plug freshly configured. I can know count on my flexbox for the future transceivers I’ll need to install/replace. Also, the optic measurement is a very good feature.