100G QSFP28 to 2x QSFP28 Breakout DAC Passive Copper Cable, 1 - 5 m

Universal Direct Attached Cable (DAC), 1 - 5 m
Use FLEXBOX to configure to almost any vendor
QSFP28 to QSFP28
Supports 100G to 4x 25G Ethernet interoperability
Supported Datarate 103.12 Gbit/s
Modules are permanently attached to each end
Low power consumption < 0.9 W (less than 0.3 W per terminal)
Connect different host systems by configuring each side individually
Specs
  • Twinax
  • 1m - 5m
  • 103.12 G
Protocols
  • 50G ETH
Selection "S2":
Country of Origin
Germany,
Thailand,
Taiwan,
Vietnam and
Malaysia
Part number
QQ.Czz1HG.z

Add Product to Quote

If you add products discounts in this quote won't be valid anymore!
You can create a quote from your cart.
Just go to cart and click CREATE QUOTE.

Specification

Compliance Code DAC Breakout
Form Factor QSFP28 to 2x QSFP28
Interface Direct Attached Cable
Length 5 m
Temperature Range 0°C - 70°C
Bandwidth 103.12 Gbit/s
Digital Diagnostic Management (DDM) not implemented
Power Consumption 0.9 W (0.3 W + 2x 0.3 W)
CDR none
Modulation NRZ
Supported Protocols 50G Ethernet

Transceiver Configuration with FLEXBOX

It's that easy to use
Insert Transceiver into FLEXBOX
1. Insert Into FLEXBOX
Select and Configure
2. Select And Configure
  • Choose vendor and compatibility
  • Press play
  • Configuration only takes a few seconds
Use with Device
3. Use With Device
  • Use the transceiver in your device. That's it!
  • Need it for another device? - Re-configure it again and again

Compatibility

All trademarks, registered companies & references cited are the sole property of their respective company and are used solely to assist in the identification of products.

  • MSA Standard compatible
  • Juniper JNP-100G-2X50G-5M compatible
  • Nvidia (ex. Mellanox) MCP7H00-G003 compatible
Your vendor / compatibility is missing?

What customers say

A must-have for every network engineer.
Never again will you have to stock different transceiver types for different vendors for the infrastructure you are using.
The setup of the FLEXBOX is very easy and self-explanatory. The configuration of the FLEXOPTIX universal transceivers is done in seconds and without any problems. Thanks to the smartphone app and the Mobility Pack, even on the go without having to lug around large equipment.

Ten out of ten, absolutely recommended!

Roman Beyerle CODESYS GmbH
The flashing is very quick and you can configure it to flash multiple devices in a row. Definitely well worth it.
Adam Montgomery Necto Inc
After many years of using clumsy EEPROM programmers, soldering irons, hammers etc. to make SFP modules work properly, now FLEXBOX allows me to do the same thing in a fraction of time. I only hope my boss doesn't find out I have so much free time now!
Adil Demiri CTO, SGN d.o.o.

The flexbox has been an amazing tool for our Equinix AM5 deployments, we have used many brands previously however the flexbox was superior right from the start, especially when working in the datacenter and not needing to hold my laptop in my hand but my phone, which is just amazing for rapid deployments.

Looking forward to keep using the flexbox in the future! :)

Stan van de Klippe Chief Executive Officer-royalehosting.net
More