400G QSFP-DD to 8x SFP56 Breakout DAC Passive Copper Cable, 0.5 - 3 m

- Twinax
- 0.5m - 3m
- 425.04 G
- 400G ETH
- 50G ETH
Specification
Compliance Code | DAC Breakout |
---|---|
Form Factor | QSFP-DD to 8x SFP56 |
Interface | Direct Attached Cable |
Operating Temperature | Standard |
Modulation | NRZ |
Length | 3 m |
---|---|
Cable Diameter | 26 AWG |
Temperature Range | 0°C - 70°C |
Bandwidth | 425.04 Gbit/s |
Digital Diagnostic Management (DDM) | not implemented |
Power Consumption | 0.9 W (0.1 W + 8x 0.1 W) |
---|---|
CDR | none |
Modulation | NRZ |
Supported Protocols | 400G Ethernet, 50G Ethernet |
Transceiver Configuration with FLEXBOX
It's that easy to use- Download and start our FLEXOPTIX App
- Connect your FLEXBOX via USB
- Insert a Universal Transceiver
- Choose vendor and compatibility
- Press play
- Configuration only takes a few seconds
- Use the transceiver in your device. That's it!
- Need it for another device? - Re-configure it again and again
Compatibility
All trademarks, registered companies & references cited are the sole property of their respective company and are used solely to assist in the identification of products.
- MSA Standard compatible
What customers say
Ordering and using FLEXOPTIX transceivers was far quicker than even getting a quote from traditional vendors.
Using the FLEXBOX is super easy and fast - 5 minutes to get transceivers ready including unboxing and enjoying packaged marshmallows.
FLEXOPTIX creates overall great and reliable products. We need optics for multiple vendors and with the FLEXBOX we are able to simplify our spare part handling.
The best part of the FLEXBOX are the Linux drivers and therefore no need for any additional OS just for branding optics.
The FLEXBOX has been an amazing tool for our fibre infrastructure upgrades as we work with different types and manufacturers of equipment, the ability to configure them on the fly when required makes the process a lot easier!
We were pleasantly surprised by the easy to use interface and the extra's such as the power meter.
The travel pack makes it easy to use it off-site in some of our satellite cabs if needed.
The FLEXOPTIX universal transceivers are very easy to configure and we will be ordering these in the future.
A must-have for every network engineer.
Never again will you have to stock different transceiver types for different vendors for the infrastructure you are using.
The setup of the FLEXBOX is very easy and self-explanatory. The configuration of the FLEXOPTIX universal transceivers is done in seconds and without any problems. Thanks to the smartphone app and the Mobility Pack, even on the go without having to lug around large equipment.
Ten out of ten, absolutely recommended!