100G QSFP28 to 4x SFP28 Breakout DAC with CDR (RX only) Active Copper Cable, 0.5 - 5 m

Universal Direct Attached Cable (DAC) with CDR (RX only), 0.5 - 5 m
Use FLEXBOX to configure to almost any vendor
QSFP28 to SFP28
Supports 100G to 4x 25G Ethernet interoperability
Supports Datarates from 25.78 to 111.8 Gbit/s
Modules are permanently attached to each end
Low power consumption < 2.5 W (less than 0.5 W per terminal)
Connect different host systems by configuring each side individually
Specs
  • Twinax
  • 0.5m - 5m
  • 111.8 G
  • Active
Protocols
  • 25G ETH
Part number
QP.Czz1HG.z.AR
You can create a quote from your cart.
Just go to cart and click CREATE QUOTE.

Specification

Type DAC Breakout
Form Factor QSFP28 to 4x SFP28
Interface Direct Attached Cable
Length 0.5 m
Temperature Range 0°C - 70°C
Bandwidth 103.12 Gbit/s - 111.8 Gbit/s
Digital Diagnostic Management (DDM) not implemented
Power Consumption 2.5 W (0.5 W + 4x 0.5 W)
CDR RX only
Modulation NRZ
Supported Protocols 25G Ethernet

Transceiver Configuration with FLEXBOX

It's that easy to use
Insert Transceiver into FLEXBOX
1. Insert Into FLEXBOX
Select and Configure
2. Select And Configure
  • Choose vendor and compatibility
  • Press play
  • Configuration only takes a few seconds
Use with Device
3. Use With Device
  • Use the transceiver in your device. That's it!
  • Need it for another device? - Re-configure it again and again

Compatibility

All trademarks, registered companies & references cited are the sole property of their respective company and are used solely to assist in the identification of products.

  • MSA Standard compatible
  • Dell (ex. Force10) DAC-Q28-4SFP28-25G-1M compatible
Your vendor / compatibility is missing?

What customers say

Ordering and using FLEXOPTIX transceivers was far quicker than even getting a quote from traditional vendors. Using the FLEXBOX is super easy and fast - 5 minutes to get transceivers ready including unboxing and enjoying packaged marshmallows.
Bronislav Robenek Network Architect, Cloud4com
It's just a genius device. So easy to use and simple! I would recommend it to every network engineer. Plug-in the module, program and its ready for deployment!
David Schoefberger Schoefberger
Our engineers spend a lot of time in data centers connecting switches and routers from different vendors. With the FLEXOPTIX service not only their task gets easier, also the back office doesn't have to have a broad range of optics from different vendors in stock anymore. The days that an engineer stand next to a router with an optic from the wrong vendor are over. With the FLEXOPTIX FLEXBOX the engineer simply reconfigures the optic, and that’s that. As an added benefit with the FLEXBOX there is no need to connect a new cross-connect to a device to see if it is connected on the other side. The measurement option that comes with the FLEXBOX are very handy!
Thomas Verschuren Technical Consultant, IP Visie Networking B.V.
Just wanted to express my giddy happiness at how fast your crack team of ninjas were able to get optics to my desk.
Donal Cunningham Senior Network Engineer - Airspeed Telecom
More